almost done now add the
2x2.5mm screw with washers to mount the Imod3 to the iopener
you can hook up you 5
volt fan to the Imod3 and free up you serial port !
This is the Imod3 ready
for a hard drive
the next step is to
install the hard drive onto the Imod3 board just slide it onto the board
Then Flip it over and
add the 3x3mm screws to hold the drive down
here is a side shot showing
the drive mounted
now just plug it in
you desktop to install the OS of your choice. !! linux !! 8>)
now align the Imod3
with the 44 pin ide header in the Imod3 iopener
almost done now add the
2x2.5mm screw with washers to mount the Imod3 to the iopener
you can hook up you 5
volt fan to the Imod3 and free up you serial port !